Wed 04 July 2012

r0ket as Universal Charger

Here’s another nice use case for the µc³ r0ket:

Since it features a build in 3.7V LiPo cell and a fitting charging controller the r0ket basically can be used to charge LiPo or LiIon single cell batteries found in phones, media players, cameras or even toy helicopters.

After I realized that I had forgot to charge my camera and didn’t bring a charger to the easterhegg either I was happy that I already had set up one of my r0kets for charging external batteries.

First you have to unplug the build in LiPo battery and attach the VCC (right) and Ground (middle) pins to the appropriate pins of the cell you want to charge. If the battery you are about to charge has a temperature sensor connect it to the leftmost pin on your r0ket. Otherwise connect the left and middle pins with a 10k resistor.

With the voltage l0dable you will even be able to monitor the charging progress.

WARNING: This setup is only meant for single cell LiIon or LiPo batteries. Bad things will start to happen, if you try to charge multiple cells in series. Also keep in mind that lithium cells can burn or even explode if not handled properly, so always be careful and don’t blame me if you fuck up your carpet.

charging a camera battery

Read more...



Sat 08 October 2011

r0ket flashlight m0dule

Per request, here are some pictures of my micro-m0dule for the Chaos Communication Camp r0ket-badge:

micro_module

torch is on


This is probably the simplest possible m0dule one can build. I only used left overs: A white smd-led, a smd-resistor, a little bit of perfboard and a few wires.

Read more...